ST-Link V2 Clone STM8 STM32 Emulator Downloader Programming Unit คละสี
ST-Link V2 Clone STM8 STM32 Emulator Downloader Programming Unit คละสี
ST-Link V2 เครื่องโปรแกรม STM32 รองรับ Arduino IDE
ST-Link/V2 mini is a small form factor clone programmer and in circuit debugger for STM8 and STM32. This mini STM programmer is a low cost alternative supports all STM32 SWD interface debugging and SWIM debugging for STM8 or STM32 series controllers. It can provide power to target 5V and 3.3V output.
ข้อมูลเพิ่มเติม ST-Link V2 Mini STM8 STM32 Emulator
- This programmer supports downloading and debugging of the full range of STM32 SWD and STM8 SWIM.
- The wiring is very simple! Its convenient and practical because the interface definition is marked directly on the case.
- It supports both 5V and 3.3V power outputs and all I/O output ports are protected.
- You can easily observe the working status with red and blue LED indicators.
- It can protect your computer motherboard since the internal board of this programmer is with 500MA self-recovery fuse
Supported Device Series:
- STM8 Series Microcontrollers
- STM32 Series Microcontrollers
Supported Interfaces:
- JTAG/serial wire debugging (SWD)
- Single wire interface module (SWIM)
Supported Development Environments:
- ST-LINK Utility 2.0 and above
- STVD 4.2.1 and above
- STVP 3.2.3 and above
- IAR EWARM V6.20 and above
- IAR EWSTM8 V1.30 and above
- KEIL RVMDK V4.21 and above
วิธีการติดตั้ง ST-Link V2 Mini STM8 STM32 Emulator
(4.88)
(2)